Hello, welcome toShenzhen Lixin mechanical equipment Co., Ltd 中文 | English

National Service Hotline:
134-1189-0882
150-1373-7393

NEWS
Contact Us
Shenzhen Lixin mechanical equipment Co., Ltd
Contacts:Mr. Xie134-1189-0882
Contacts:Mr. Zhou 150-1373-7393
Address:No.5, Lane 2, Tanluo new village 1, Dalang street, Longhua New District, Shenzhen

News Center

Three minutes to understand how to build the disc scaffold, come in and have a look

Time of publication:2020-07-21 17:23:57
Three minutes to understand how to build the disc scaffold, come in and have a look

 Three minutes to understand how to build the disc scaffold, come in and have a look

 
Hello, everyone. I'm Xiaobian. The so-called disc scaffold refers to the socket type disc buckle scaffold. How to build the disc scaffold? Is there any erection specification? Who knows what matters should be paid attention to in the construction of disc scaffold? Let me tell you.
 
脚手架厂家.jpg
 
Specification for erection of disc scaffold:
 
1. Adjustable base bracket
 
After setting out according to the size of the scaffold configuration drawing, arrange the adjustable base to the fixed point.
 
2. Put the sleeve part of the main frame of the [standard base] upward into the upper part of the adjustable base, and mark that the lower edge of the base should be completely placed in the groove of the wrench stress plane.
 
3. Level Yi crossbar
 
Put the head of the cross bar into the hole position of the disc so that the front end of the cross bar is against the round pipe of the vertical pole, and then the wedge-shaped pin is used to penetrate the small hole to knock and fix.
 
4. Starting pole
 
The vertical pole without (connecting rod) is collectively referred to as the starting vertical pole. Insert the long end of the starting vertical rod into the sleeve of the standard base as shown in the figure below. Check the position of the hole to see if the [starting pole] is inserted into the bottom of the sleeve. [starting pole] only used in the Yi layer lap lap, the second layer upward use [docking pole].
 
5. Second floor crossbar
 
Install the second layer crossbar according to step 3.
 
6. Inclined bar of layer Yi
 
Assemble all the diagonal bars clockwise or anticlockwise. Put the [inclined rod] into the large hole position of the disc, so that the front end of the inclined rod head is against the circular pipe of the main frame, and then the wedge pin is used to penetrate through the large hole to knock and fix.
 
7. Butt stand
 
[butt stand] is connected by (connecting rod), as shown in the figure below, the connecting rod can be inserted into the lower pipe.
 
If it is necessary to use the [buttress pin], be sure to check that the disc alignment holes are in the same direction.
 
8. The third floor crossbar
 
Install the third layer crossbar according to step 3.
 
9. Second layer inclined rod:
 
According to the assembly method in step 6, lap the second layer [diagonal bar] in the same direction as layer Yi.
 
If the Yi layer is assembled in a counter clockwise direction, the inclined rods above the second layer should also be assembled in a counter clockwise direction.
 
10. U-shaped adjusting seat
 
Insert the screw pipe of the [U-shaped adjusting seat] into the upright tube, and then adjust it to the required height with a wrench. The buckle scaffold is built according to the corresponding standards and specifications, and is built layer by layer to ensure safety.